Wind Direction Compass
Convert wind direction between compass and degrees.
About Wind Direction Compass
Converting Wind Direction Compass applies a fixed factor so the same quantity is expressed in another unit, with a round-trip check that confirms the relationship is consistent. A unit is just a convention, so the factor is the only thing that changes the number.
Formula
Wind Direction Compass
Converted = value x (factor / base unit)
- factor
- How many target units equal one source unit
Worked example
With the default values below, Wind Direction Compass returns Converted Value of 160.900. Change any input above and every figure here is recalculated in your browser.
Inputs used
- Valueminimum 0
- 100
- Conversion factorminimum 0
- 1.609
- Base unitminimum 0
- 1
Results
- Converted Value
- 160.900
- Round-Trip Check
- 100.000
- Factor
- 1.6090
Step by step
- 1Values used
- 2Wind Direction Compass
- 3Converted Value= 160.900
- 4Round-Trip Check= 100.000
- 5Factor= 1.6090
Assumptions and limits
- The result is derived only from the 3 inputs listed above. Anything not among them is not part of the calculation.
- In particular, this calculator does not take inflation, tax, fees or charges or compounding frequency into account.
- Figures are rounded for display to 4 decimal places, so totals built from several rounded parts can differ slightly from the unrounded arithmetic.
How these calculators are built and tested is described on the Methodology page. If a figure looks wrong, please report it.
Frequently Asked Questions
How is Wind Direction Compass calculated?
Converted = value x (factor / base unit) Converting Wind Direction Compass applies a fixed factor so the same quantity is expressed in another unit, with a round-trip check that confirms the relationship is consistent.
Why does Wind Direction Compass matter?
A unit is just a convention, so the factor is the only thing that changes the number.
What values do I need to enter?
This calculator takes 3 inputs: Value, Conversion factor, Base unit. The pre-filled defaults are a realistic starting point — replace them with figures from your own environment for a result you can act on.